Table of Contents
Advertisement
ACL Commands
no sequence
no sequence
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
mac access-list extended
no mac access-list extended
Parameters
acl-name
•
—Name of the MAC-based ACL. (Range: 1 to 32 characters)
Default Configuration
No MAC-based ACL is defined.
Command Mode
Global Configuration mode
User Guidelines
The MAC-based ACEs for this MAC-based ACL are defined in the permit (MAC)
and deny (MAC) commands.
A MAC-based ACL is defined by a unique name. IPv4-based ACL, IPv6-based
ACL, MAC-based ACL, or policy map cannot have the same name.
Example
switchxxxxxx(config)# mac access-list extended server1
switchxxxxxx(config-mac-acl)# permit 00:00:00:00:00:01 00:00:00:00:00:ff any
To remove a permit or deny ACE for an IPv4-based ACL, an IPv6-based ACL, or a
MAC-based ACL, use the no sequence command in the IP Access-List
Configuration mode, in the IPv6 Access-List Configuration mode, or in the MAC
Access-List Configuration mode.
Syntax
value
no sequence
acl-nam
e
acl-name
4
78
Advertisement
Table of Contents
