Voice Vlan Enable; Voice Vlan Aging-Timeout - Cisco 220 Series Smart Plus Reference Manual

Smart plus switches command line interface
Hide thumbs Also See for 220 Series Smart Plus:
Table of Contents

Advertisement

Voice VLAN Commands

voice vlan enable

voice vlan enable

voice vlan aging-timeout

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable the administrative voice VLAN on an interface, use the voice vlan enable
Interface Configuration mode command.
To disable the administrative voice VLAN on an interface, use the no form of this
command.
Syntax
voice vlan enable
no voice vlan enable
Default Configuration
Disabled
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# voice vlan enable
To set the aging timeout of the OUI voice VLAN, use the voice vlan aging-timeout
Global Configuration mode command.
Syntax
vocie-vlan aging-timeout
Parameters
minutes
—The time delay in minutes to remove an interface from the voice
VLAN after all MAC addresses of the phones detected on the interfaces
have aged out. (Range: 30 to 65536 minutes)
minutes
40
492

Advertisement

Table of Contents
loading

Table of Contents