Ipv6 Mld Snooping - Cisco 220 Series Smart Plus Reference Manual

IPv6 MLD Snooping Commands

ipv6 mld snooping

ipv6 mld snooping
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# ipv6 mld profile 20
switchxxxxxx(config-mld-profile)#
To enable IPv6 MLD snooping on the switch, use the ipv6 mld snooping Global
Configuration mode command.
To disable IPv6 MLD snooping, use the no form of this command.
Syntax
ipv6 mld snooping [version {1 | 2}]
no ipv6 mld snooping
Parameters
• version 1—(Optional) Specifies the MLD operation version as v1.
• version 2—(Optional) Specifies the MLD operation version as v2.
Default Configuration
The default MLD version is v1.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# ipv6 mld snooping
19
280