Ethernet Configuration Commands
storm-control unknown-multicast
storm-control unknown-multicast
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# storm-control unit pps
To enable storm control for unknown multicast traffic on an interface, use the
storm-control unknown-multicast Interface Configuration mode command.
To disable storm control for unknown multicast traffic, use the no form of this
command.
Syntax
storm-control unknown-multicast
no storm-control unknown-multicast
Parameters
N/A
Default Configuration
Disabled
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# storm-control unknown-multicast
11
174