Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
show power inline
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
The following table describes the significant fields shown in the example:
Field
Port
State
Status
Priority
Class
Max. Power (Admin)
Device
Overload
Short Current
Power Denied
MPS Absent
Invalid Sig.
Description
Port number.
Shows that the port is enabled to provide power. The
possible values are Auto or Never.
Power operational state. The possible values are on,
off, test-fail, testing, searching, or fault.
Port inline power management priority. The possible
values are critical, high, or low.
Power consumption classification of the powered
device.
Maximum amount of power in milliwatts assigned to
the PD connected to the selected port. In Class Limit
mode, the value of the maximum power allocation will
be determined on the class detection of PD connected,
15.4 w (802.3af, class 0 to 3), and 30 W (802.3at, class
4). In Power Limit mode, the value of maximum power
allocation will be determined by the PoE standard of
the port, 15.4 w (802.3af), and 30 W (802.3at).
Description of the powered device from CDP.
Number of overload conditions detected.
Number of short conditions detected.
Number of times that the power was denied.
Number of times that the power was removed
because the powered device dropout was detected.
Number of times that an invalid signature of a powered
device was detected.
25
367
Advertisement
Table of Contents
