Table of Contents
Advertisement
Ethernet Configuration Commands
storm-control broadcast
storm-control broadcast
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
no storm-control action
Parameters
•
drop—Drops incoming packets when the received packets exceed the
maximum rate on an interface.
•
shutdown—Shuts down the interface when the received packets exceed
the maximum rate on an interface.
Default Configuration
The default action is drop.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# storm-control action drop
To enable storm control of broadcast traffic on an interface, use the storm-control
broadcast Interface Configuration mode command.
To disable storm control of broadcast traffic, use the no form of this command.
Syntax
storm-control broadcast
no storm-control broadcast
Parameters
N/A
Default Configuration
Disabled
11
170
Advertisement
Table of Contents
