STP Commands
show spanning-tree
show spanning-tree
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
value
•
—Specifies an unsigned 16-bit number that identifies the revision of
the current MSTP configuration. (Range: 0 to 65535)
Default Configuration
The default revision number is 0.
Command Mode
MST Configuration mode
Example
switchxxxxxx(config)# spanning-tree mst configuration
switchxxxxxx(config-mst)# revision 1
To show the STP configuration, use the show spanning-tree Privileged EXEC
mode command.
Syntax
show spanning-tree
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show spanning-tree
Spanning tree enabled mode STP
33
419