Table of Contents
Advertisement
CDP Commands
show cdp interfaces
show cdp interfaces
show cdp neighbor
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To show information for the interfaces on which CDP is enabled, use the show cdp
interfaces Privileged EXEC mode command.
Syntax
show cdp interfaces
Parameters
•
interface-id
—The interface ID or a list of interface IDs.
Command Mode
Privileged EXEC Mode
Example
switchxxxxxx# show cdp interfaces fa11
---------------------------------------------
CDP is globally enabled
CDP log duplex mismatch
Globally is enabled
Per interface is enabled
CDP log voice VLAN mismatch
Globally is enabled
Per interface is enabled
CDP log native VLAN mismatch
Globally is enabled
Per interface is enabled
fa11 is
Down, CDP is enabled
Sending CDP packets every 200 seconds
Holdtime is 180 seconds
To show the CDP neighbor information, use the show cdp neighbor Privileged
EXEC mode command.
Syntax
show cdp neighbor [detail]
interface-id
7
116
Advertisement
Table of Contents
