Table of Contents
Advertisement
RADIUS Commands
radius-server host
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
timeout
•
timeout
switch waits for an answer from the RADIUS server before retrying the
query, or switching to the next server. If there is no value entered in this field,
the switch uses the default timeout value. (Range: 1 to 30, default: 3)
•
usg-type {802.1x | all | login}—(Optional) Specifies the authentication type of
the RADIUS server. The possible values are:
-
802.1x—The RADIUS server is used for 802.1x port authentication.
-
all—The RADIUS server is used for user login authentication and 802.1x
port authentication.
-
login—The RADIUS server is used for user login authentication
(authenticating users that want to administer the switch).
Default Configuration
The default authentication port number is 1812.
If timeout is not specified, the global value (set in the radius-server default-param
command) is used.
If retransmit is not specified, the global value (set in the radius-server default-
param command) is used.
If key-string is not specified, the global value (set in the radius-server default-
param command) is used.
If a parameter was not set in one of the above commands, the default for that
command is used. For example, if a timeout value was not set in the current
command, the default timeout set in the radius-server default-param command is
used.
The default authentication type is all.
Command Mode
Global Configuration mode
User Guidelines
To specify multiple hosts, this command is used for each host.
Example
The following example specifies a RADIUS server with IP address 192.168.10.1,
authentication request port number 20, and a 20-second timeout period:
—(Optional) Specifies the number of seconds that the
29
419
Advertisement
Table of Contents
