Table of Contents
Advertisement
Management ACL Commands
management access-class
management access-class
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
User Guidelines
The rules with Ethernet and port channel parameters are valid only if an IP address
is defined on the appropriate interface.
Example
switchxxxxxx(config)# management access-list mlist
switchxxxxxx(config-macl)# deny ip 192.168.1.111/0.0.255.255 interfaces gi11
service http
switchxxxxxx(config-macl)# exit
To restrict the management connections by defining the active management ACLs,
use the management access-class Global Configuration mode command.
To disable the management connection restrictions, use the no form of this
command.
Syntax
management access-class {console-only |
no management access-class
Parameters
•
console-only—Specifies that the switch can be managed only from the
console.
name
•
—The ACL name to be used.
Default Configuration
The default is no management connection restrictions.
Command Mode
Global Configuration mode
name
}
23
346
Advertisement
Table of Contents
