Cisco 220 Series Smart Plus Reference Manual page 463

SNMP Commands
snmp-server user
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
username groupname
snmp-server user
username groupname
snmp-server user
PRIVPASSWD
no snmp-server user
Parameters
username
• —Specifies the name of the user on the host that connects to the
SNMP agent. (Range: 1 to 30 characters). For SNMP v1 or v2c, this
username must match the community string entered in the snmp-server
host command.
groupname
• —Specifies the SNMP group to which the SNMP user belongs.
The SNMP group should be configured using the snmp-server group
command with v1 or v2c parameters. (Range: 1 to 30 characters)
• auth {md5 | sha}—(Optional) Specifies the protocol to authenticate the
SNMP user. The options are:
- md5—Uses the HMAC-MD5-96 authentication protocol.
- Sha—Uses the HMAC-SHA-96 authentication protocol.
AUTHPASSWD
•
characters)
PRIVPASSWD
• priv
(Length: 8 to 64 characters)
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# snmp-server user tom acbd
[auth {md5 | sha}
auth {md5 | sha}
username
—(Optional) The authentication password. (Length: 8 to 32
—Specifies the private password for the privacy key.
32
AUTHPASSWD
]
AUTHPASSWD
priv
447