Table of Contents
Advertisement
Configuration and Image File Commands
boot system
boot system
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx(config)# boot host auto-config
To specify the active system image file that will be loaded at startup, use the boot
system Global Configuration mode command.
Syntax
boot system {image-1 | image-2}
Parameters
•
image-1—Specifies that image1 will be loaded as the system image during
the next startup.
•
image-2—Specifies that image2 will be loaded as the system image during
the next startup.
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
The following example specifies image1 as the active system image file:
switchxxxxxx(config)# boot system image-1
Select "image1" Success
9
132
Advertisement
Table of Contents
