Ipv6 Acl Configuration Example; Network Requirements - H3C S5500-EI series Operation Manual

Operation Manual – ACL
H3C S5500-EI Series Ethernet Switches
3.5 Displaying and Maintaining IPv6 ACLs
Display information about a
specified or all IPv6 ACLs
Display information about ACL
uses of a switch
Display the configuration and
status on time range
Clear statistics about a specified
or all IPv6 ACLs that are
referenced by upper layer
software

3.6 IPv6 ACL Configuration Example

3.6.1 Network Requirements

As shown in
Configure an ACL to deny access of the R&D department to external networks.
3.6.2 Network Diagram
Figure 3-1 Network diagram for IPv6 ACL configuration
3.6.3 Configuration Procedure
# Create an IPv6 ACL 2000.
<Switch> system-view
[Switch] acl ipv6 number 2000
[Switch-acl6-basic-2000] rule deny source 4050::9000/120
[Switch-acl6-basic-2000] quit
To do...
Figure 3-1, a company interconnects its departments through the switch.
Chapter 3 IPv6 ACL Configuration
Use the command...
display acl ipv6
{ acl6-number | all | name
acl6-name }
display acl resource
display time-range
{ time-name | all }
reset acl ipv6 counter
{ acl6-number | all | name
acl6-name }
3-6
Remarks
Available in
any view
Available in
any view
Available in
any view
Available in
user view