Ipv6 Application Configuration; Introduction To Ipv6 Applications; Configuring Ipv6 Applications; Ipv6 Ping - H3C S3100 Series Operation Manual

H3c s3100 series ethernet switches operation manual

Hide thumbs Also See for S3100 Series:

Table of Contents

IPv6 Application Configuration

IPv6 are supporting more and more applications. Most of IPv6 applications are the same as those of

IPv4. The applications supported on H3C S3100 Series Ethernet Switches are:

The ping ipv6 command is commonly used for testing the reachability of a host. This command sends

an ICMPv6 message to the destination host and records the time for the response message to be

received. For details about the ping command, refer to System Maintenance and Debugging.

After you execute the ping ipv6 command, you can press Ctrl+C to terminate the ping operation.

Table 2-1 Ping IPv6

When you use the ping ipv6 command to verify the reachability of the destination, you must specify the

"–i" keyword if the destination address is a link-local address.

The traceroute ipv6 command is used to record the route of IPv6 packets from source to destination,

so as to check whether the link is available and determine the point of failure.

Use the command...

ping ipv6 [ -a source-ipv6 | -c count | -m interval | -s

packet-size | -t timeout ]* remote-system [ -i

interface-type interface-number ]

Available in any view

Table of Contents