Configuring To Output System Information To A Log Host - H3C S5500-SI Series Operation Manual

Operation Manual – Information Center
H3C S5500-SI Series Ethernet Switches
Configure the source of
the output information
Configure the format of
the time stamp
II. Enabling the display of system information on a monitor terminal
After configuring to output system information to a monitor terminal, you need to enable
the associated display function in order to display the output information on the monitor
terminal.
Perform the following configurations to enable the display of system information on a
monitor terminal:
Enable the monitoring of
system information on a
monitor terminal
Enable the display of
debug information on a
monitor terminal
Enable the display of log
information on a monitor
terminal
Enable the display of trap
information on a monitor
terminal

1.2.3 Configuring to Output System Information to a Log Host

Follow these steps to configure to output system information to a log host:
To do...
info-center
{ modu-name | default }
channel
{
channel-name } [ debug
{ level severity | state
state }* | log { level
severity | state state }* |
trap { level severity |
state state }* ]*
info-center
{ log | trap | debugging }
{ boot | date | none }
To do...
terminal monitor
terminal debugging
terminal logging
terminal trapping
Chapter 1 Information Center Configuration
Use the command...
source
channel-number
timestamp
Use the command...
1-7
Remarks
|
Required
Optional
By default, the time stamp
for log and
information is date, and
that for debugging
information is boot.
Remarks
Required
The monitoring of system
information on
monitoring terminal
disabled.
Required
Disabled by default
Optional
Enabled by default
Optional
Enabled by default
trap
the
is