Configuring Vlan Marking; Configuring Queue Scheduling - H3C S3100 Series Operation Manual

2) Method II
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-redirect vlan 2 inbound ip-group 2000 interface Ethernet1/0/7

Configuring VLAN Marking

Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual
for information about defining ACL rules.
The port where VLAN marking is to be configured is determined.
The target VLAN ID, that is, the VLAN ID to be set for traffic, is determined.
Configuration procedure
Table 1-28 Configure VLAN marking
Operation
Enter system view
Enter Ethernet port view
Configure VLAN
marking to change the
VLAN ID carried in the
incoming traffic
matching a specific ACL
rule to the specified
VLAN ID
VLAN marking is mutually exclusive with VLAN mapping.

Configuring Queue Scheduling

Refer to section
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters are determined.
Configuration procedure
Table 1-29 Configure queue scheduling
Operation
Enter system view
system-view
interface interface-type interface-number
traffic-remark-vlanid inbound acl-rule
remark-vlan remark-vlanid
Queue Scheduling for information about queue scheduling.
system-view
Command
Command
1-24
Description
—
—
Required
By default, VLAN marking
is not configured.
Description
—