Configuring The Line Rate; Configuration Procedure; Displaying And Maintaining Traffic Policing, Gts, And Line Rate - H3C S5500-SI Series Operation Manual

Configuring the Line Rate

Configuration Procedure

Follow these steps to configure the line rate:
To do...
Enter system view
Enter
Enter
interface
interface
view
view or
Enter port
port group
group
view
view
Configure the outbound
line rate for the
interface/port group
Configuration Example
Limit the outbound line rate of GigabitEthernet 1/0/1 to 512 kbps.
# Enter system view.
<Sysname> system-view
# Enter interface view.
[Sysname] interface gigabitethernet 1/0/1
# Limit the outbound line rate of GigabitEthernet 1/0/1 to 512 kbps.
[Sysname-GigabitEthernet1/0/1] qos lr outbound cir 512

Displaying and Maintaining Traffic Policing, GTS, and Line Rate

On the S5500-SI series switches, you can configure traffic policing in policy-based approach. For
related displaying and maintaining commands, refer to
To do...
Display interface line rate
configuration information
Use the command...
system-view
interface interface-type
interface-number
port-group manual port-group-name
qos lr outbound cir
committed-information-rate [ cbs
committed-burst-size ]
Use the command...
display qos lr interface
[ interface-type
interface-number ]
4-5
—
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port
group.
Required
Displaying and Maintaining QoS
Available in any view
Remarks
Policies.
Remarks