Korg Electronic Keyboard Parameter Manual page 514

Sequencer mode
(Tempo)
For more information, see "Tempo" on page 5.
7–5b: GE Real-Time Parameters for
Module Control = Master
GE PARAMETER
MIN (Minimum Value)
MAX (Maximum Value)
VALUE
ASSIGN
POL.ARITY
For more information, see "7–5b: GE Real-Time
Parameters" on page 110 and "7–5b: GE Real-Time
Parameters for Module Control = Master" on page 383.
Note: Normally, the "MIN," "MAX," "VALUE," and
"POLARITY" parameters of each module are specified
in module A, B, C, and D. These parameter settings are
possible if you specify "ASSIGN" in Master A, B, C,
and D.
For example, if you want to use Slider1 to control the
GE REALTIME PARAMETER No.1 of modules A, B, C,
and D when Module Control is set to Master, you
would set the Master, A, B, C, and D's GE REALTIME
PARAMETER No.01 "ASSIGN" to Slider1. If these are
set to "ASSIGN," you are able to edit the "MIN,"
"MAX," "VALUE," and "POLARITY" parameters for
Master, A, B, C, and D.
In this way, you can make GE realtime parameter
settings independently of modules A, B, C, and D.
7–5c: GE Real-Time Parameters for
Module Control = A, B, C, D (1-32)
For more information, see "7–5b: GE Real-Time
Parameters" on page 110, and "7–5c: GE Real-Time
Parameters for Module Control = A, B, C, D" on
page 384.
7–5d: Scene Matrix
For more information, see "7–5d: Module Control
Scene Matrix" on page 384.
▼ 7–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Memory Status. For more information, see
"Memory Status" on page 524.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy KARMA Module. For more information,
see "Copy KARMA Module" on page 408.
504
[040.00...240.00, EXT]
[Parameter Name]
[–5000...+5000]
[–5000...+5000]
[–5000...+5000]
[---, Slider1...8, Slider (SW)1...8,
SW1...8, DynaMIDI1...8]
• 3: Initialize KARMA Module. For more
information, see "Initialize KARMA Module" on
page 409.
• 4: Copy Scene. For more information, see "Copy
Scene" on page 409.
• 5: Swap Scene. For more information, see "Swap
Scene" on page 409.
• 6: Capture Random Seed. For more information,
see "Capture Random Seed" on page 409.
• 7: FF/REW Speed. For more information, see
"FF/REW Speed" on page 525.
• 8: Set Location (for Locate Key). For more
information, see "Set Location (for Locate Key)" on
page 525.
• 9: Copy From Program. For more information, see
[+, –]
"Copy From Program" on page 526.