028: Od/Hypergain Wah - Korg Electronic Keyboard Parameter Manual

OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.

028: OD/HyperGain Wah

This distortion effect has two modes: overdrive and
hyper-gain that produces a strong distortion. A higher
high-gain setting is required for this effect relative to a
normal-size effect.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Mode: Overdrive / Hyper-Gain
Drive
Pre Low-cut
+
Wah Driver
Output Level
Direct Mix
Right
D -mod
WAH
Wah Switch
Source
Mode
These parameters let you turn the Wah on and off from
either the LCD or a controller, and determine how the
controller works. For more information, see "Wah
Switch" on page 788.
Sweep Range
Source
These parameters set the modulation source and
amount for the Wah. For more information, see "Wah
Sweep" on page 788.
DRIVE
Pre Low-cut
This attenuates low frequencies before the signal enters
the distortion. Use this to create a sharper tone.
Drive Mode
Switches between overdrive and hyper-gain mode.
Drive
Sets the degree of distortion. For more information, see
"DRIVE" on page 788.
Direct Mix
Amount of the dry sound mixed to the distortion.
Speaker Simulation
Speaker simulation on/off.
Output Level
Sets the output level. For more information, see
"DRIVE" on page 789.
Overdrive, Amp models, and Mic models
Wet / Dry
3 Band EQ
Amp Simulation
Wet / Dry
[Off, On]
[Off...Tempo]
[Toggle, Moment]
[–10...+10]
[Off...Tempo]
[0...10]
[Overdrive, Hyper-Gain]
[1...120]
[0...50]
[Check-box]
[0...50]
Source
Selects the modulation source for the output level.
Amount
Sets the modulation amount of the output level.
EQ
Low Fc [Hz]
Sets the center frequency for Low EQ (shelving type).
Gain [dB]
Sets the gain of the Low EQ.
Mid1 Fc [Hz]
Sets the center frequency for Mid/High EQ 1 (peaking
type).
Q
Sets the band width of Mid/High EQ 1. p.773.
Gain [dB]
Sets the gain of Mid/High EQ 1.
Mid2 Fc [Hz]
Sets the center frequency for Mid/High EQ 2 (peaking
type).
Q
Sets the band width of Mid/High EQ 2. p.773.
Gain [dB]
Sets the gain of Mid/High EQ 2.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
028: OD/HyperGain Wah
[Off...Tempo]
[–50...+50]
[20...1.00k]
[–18...+18]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
[–18...+18]
789