051: Stereo Phaser - Korg Electronic Keyboard Parameter Manual

Decay
Sets the EG decay time.
FLANGER
L Delay Bottom [msec]
Sets the lower limit of the left-channel delay time. For
more information on the Bottom and Top settings, see
the graphic under "Frequency Bottom" on page 777.
L Delay Top [msec]
Sets the upper limit of the left-channel delay time.
R Delay Bottom [msec]
Sets the lower limit of the right-channel delay time.
R Delay Top [msec]
Sets the upper limit of the right-channel delay time.
Feedback
This controls the intensity of the flanger. For more
information, see "Feedback" on page 803.

051: Stereo Phaser

This effect creates a swell by shifting the phase. It is
very effective on electric piano sounds. You can add
spread to the sound by offsetting the phase of the left
and right LFOs from each other
Stereo In - Stereo Out
Left
Right
LFO: Tri / Sine LFO Shape
PHASER
Manual
Sets the phaser's center frequency.
Depth
Sets the depth of LFO modulation.
Source
Selects the modulation source for the LFO modulation
depth.
Amount
Sets the modulation amount of the LFO modulation
depth.
Resonance
This controls the intensity of the phaser effect. Positive
and negative values create different timbres.
[1...100]
[0.0...50.0]
[0.0...50.0]
[0.0...50.0]
[0.0...50.0]
[+/–100]
Wet / Dry
Phaser
Resonance
High Damp
Phaser
Wet / Dry
LFO Phase
[0...100]
[0...100]
[Off...Tempo]
[+/–100]
[+/–100]
Chorus, Flanger, and Phaser
High Damp [%]
This parameter sets the amount of damping of the
feedback in the high range. Increasing the value will
cut high-range harmonics.
OUTPUT
Wet/Dry [–Wet...–1:99, Dry, 1: 99...Wet]
Sets the balance between the "wet" processed sound
and the dry input. Negative values invert the phase of
the wet signal. This interacts with Feedback; for more
information, see "Feedback" on page 803.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
Mixing the processed and dry signals via Wet/Dry will
enhance the effect. For maximum intensity, set
Resonance and Wet/Dry so that they are either both
positive or both negative; this emphasizes the phaser's
harmonic peaks.
High Damp [%]
This parameter sets the amount of damping of the
resonance in the high range. Increasing the value will
cut high-range harmonics.
LFO
Waveform
Selects the LFO Waveform.
Shape
Changes the curvature of the LFO Waveform. p.780.
Phase [degrees]
Sets the LFO phase difference between the left and
right. See "Phase [degrees]" on page 779.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
051: Stereo Phaser
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
[Triangle, Sine]
[+/–100]
[–180...+180]
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
805