Table of Contents
Advertisement
Sampling P0: Recording
This page is where you make basic settings for
recording (sampling), including:
• Creating and editing multisamples and indexes
• Specifying the writing-destination for the samples
you record, and selecting either mono or stereo
samples
0–1: Recording
0–1a
0–1b
0–1d
Here you can create and edit multisamples and
indexes, specify the writing-destination for the
samples you record, and select stereo or mono
sampling. You can also specify the sampling time, loop
settings, +12 dB boost, and adjust the final level of the
input signal.
Note: Normally you will perform sampling while in
this page (Recording or Audio Input).
Note: If you have not yet made audio input settings, go
to P0– Audio Input page and make these settings
before you proceed.
0–1a: Multisample Select (MS)
Multisample Select (MS)
Selects the multisample.
Each multisample consists of the samples for one or
more indexes (an Index is a range or zone of keys).
This parameter can also be set from P1–P3.
To create a new multisample,
1. Press the "Multisample Select" popup button to
access the popup menu, and select a number for
which the multisample name is blank.
• Specifying the sampling time, loop settings, and
+12 dB boost
• Specifying the output destinations for the external
audio inputs
• Selecting the source to sample
• Setting the recording level
0–1f
Alternatively, use the numeric keys 0–9 to specify a
new multisample number, and press the ENTER
switch.
When you select a new multisample number, the
"Create New Multisample" dialog box will appear.
2. If you wish to create a stereo multisample, check
"Stereo."
[000...999]
3. To create the multisample, press the OK button. To
cancel, press the Cancel button.
A multisample will be created as follows (example).
Mono type 001: NewMS_ _ _ _ _ _ _ _ _ _ _ _ _ _001
Stereo type 001: NewMS_ _ _ _ _ _ _ _ _ _ _ _ _ _001–
Sampling P0: Recording
0–1PMC
0–1c
0–1e
L
002: NewMS_ _ _ _ _ _ _ _ _ _ _ _ _ _001–
R
0–1: Recording
567
Advertisement
Table of Contents
