Korg Electronic Keyboard Parameter Manual page 357

Timbre 01 (Timbre Number)
Auto Load Prog EQ
When you first load a Program into a Timbre, this
parameter determines whether or not the Program's
EQ settings will be loaded as well.
Once the Program has been loaded, you can change
any or all of the EQ settings as desired. All such edits
are stored in the Combination, without affecting the
original Program.
Regardless of this setting, subsequent edits to the
Program's EQ in Program mode will not affect the
Combination.
On: the Program's EQ settings will be loaded
automatically along with the Program. This is the
default setting.
Off: the Program's EQ settings won't be loaded. Use
this if you've set up the EQ in a specific way, and then
want it to stay unchanged while you try out different
Programs.
Bypass
If this is On (checked), all of the EQ will be disabled,
including "Input Trim." Bypass can be convenient for
comparing the results of the EQ with the original
signal.
Input Trim
This controls the volume level going into the EQ. Note
that this parameter uses a linear scale; 50 is equivalent
to –6dB, 25 is the same as –12dB, and so on.
High settings of the Low, Mid, and High Gain controls
can cause substantial increases in the overall level. You
can compensate for this by turning down the input
trim.
High Gain
This controls the gain of the 10kHz High Shelf EQ, in
increments of 0.5dB.
Mid Frequency
This sets the center frequency for the Mid sweep EQ.
Mid Gain
This controls the gain of the Mid Sweep EQ, in
increments of 0.5dB.
Low Gain
This controls the gain of the 80Hz Low Shelf EQ, in
increments of 0.5dB.
Timbre 02...16 (Timbre Number)
These parameters adjust the three-band EQ (with
sweepable mid range) for timbres 2 through 16. They
are the same as for timbre 1. See "Timbre 01".
▼ 1–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
[Off, On]
[On, Off]
[00...99]
[–18.0...+00.0...+18.0dB]
[100Hz...10kHz]
[–18.0...+00.0...+18.0dB]
[–18.0...+00.0...+18.0dB]
Combination P1: EQ/Vector/Controller
• 0: Write Combination. For more information, see
"Write Combination" on page 405.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy From Program. For more information, see
"Copy From Program" on page 405.
• 3: Show EQ Graphic. For more information, see
"Show EQ Graphic" on page 407.
1–1: Timbre EQ
347