039: St. Mic Modeling +Preamp - Korg Electronic Keyboard Parameter Manual

Effect Guide
MIC SIMULATOR
Type [Vnt.Dy/55SH, Mlt.Cn/C414, Pc.Cn/C451,
Whale/MD421, Vo.Dy/SM58, Mlt.Dy/SM57,
Vo.Cn/U87, Vo.Tube/U47, BDr.Dy/RE20]
Selects the type of mic.
Position
This expresses the effect that the mic position has on
the sound. The Close setting is the closest mic position,
and the Far setting is the farthest.
TUBE PREAMP
Low Cut [Hz]
Sets the frequency of the low cut filter.
High Cut [Hz]
Sets the frequency of the high cut filter.
Gain [dB]
Sets the input gain to the vacuum tube preamp.
Saturation [%]
Sets the input/output response of the preamp.
At higher settings, the waveform will change at high
gain levels, tending to cause distortion. Lower settings
will produce linear response.

039: St. Mic Modeling +PreAmp

Stereo In - Stereo Out
Left
Mic Simulation
Mic Simulation
Right
This similar to "038: Mic Modeling +PreAmp", but in
stereo. For example, you might use this to simulate
micing of a stereo source such as a rotary speaker.
For more information, see "038: Mic Modeling
+PreAmp" on page 795.
796
[Close, On, Off, Far]
[Thru, 21...8.00k]
[53...20.00k, Thru]
[–24.0...+24.0]
[0...100]
Wet / Dry
Tube Pre Amp
Output Level
Tube Pre Amp
Wet / Dry
Mic/Pre Amp - Saturation
Out
Saturation = 0
Saturation = 50
Saturation = 100
In
Bias = 0
Bias
This expresses the effect that changes in vacuum tube
bias have on the distortion of the waveform. Higher
settings of this value will produce distortion even at
low gain levels. Since this will also change the
overtone structure, you can use it to control the tonal
character.
Mic/Pre Amp - Bias
Out
Bias = 100
Bias = 50
Bias = 0
In
Satulation = 50
Output Level [dB]
Sets the output level of the preamp.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
[0...100]
[–48.0...+0.0]