121: Limiter - P4Eq; 122: Limiter - Chorus/Flanger - Korg Electronic Keyboard Parameter Manual

121: Limiter - P4EQ

This effect combines a mono limiter and a four-band
parametric equalizer. You can change the order of the
effects.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Limiter
+
Limiter
Gain Adjust
Right
Envelope - Control
Routing
[Limiter ➝ P4EQ, P4EQ ➝ Limiter]
Routing
Switches the order of the limiter and parametric EQ.
LIMITER
Ratio
Sets the signal compression ratio. p.765.
Threshold [dB]
Sets the level above which the compressor is applied.
p.766.
Attack
Sets the attack time. p.766.
Release
Sets the release time. p.766.
Gain Adjust [dB]
Sets the limiter output gain. p.766.
PARAMETRIC EQ
Trim
Sets the parametric EQ input level.

122: Limiter - Chorus/Flanger

This effect combines a mono limiter and a
chorus/flanger. You can change the order of the effects.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Routing
Limiter
+
Limiter
EQ Trim
LEQ HEQ
Gain Adjust
Right
Envelope - Control
Wet / Dry
Routing
Parametric 4Band EQ
Trim
Wet / Dry
[1.0 : 1...50.0 :1, Inf :1]
[–40...0]
[1...100]
[1...100]
[–Inf, –38...+24]
[0...100]
Wet / Dry
Chorus/Flanger
Chorus/Flanger
Normal
+
Output Mode
—
Wet Invert
Feedback
Cho/Flng Wet / Dry
Wet / Dry
LFO: Tri / Sine
Mono-Mono Serial
Band1 Fc [Hz]
Sets the center frequency of Band 1.
Q
Sets the bandwidth of Band 1. p.773.
Gain [dB]
Sets the gain of Band 1.
Band2 Fc [Hz]
Sets the center frequency of Band 2.
Q
Sets the bandwidth of Band 2. p.773.
Gain [dB]
Sets the gain of Band 2.
Band3 Fc [Hz]
Sets the center frequency of Band 3.
Q
Sets the bandwidth of Band 3. p.773.
Gain [dB]
Sets the gain of Band 3.
Band4 Fc [Hz]
Sets the center frequency of Band 4.
Q
Sets the bandwidth of Band 4. p.773.
Gain [dB]
Sets the gain of Band 4.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Routing
[Limiter ➝ Flanger, Flanger ➝ Limiter]
Routing
Switches the order of the limiter and chorus/flanger.
LIMITER
Ratio
Sets the signal compression ratio. p.765.
Threshold [dB]
Sets the level above which the compressor is applied.
p.766.
121: Limiter - P4EQ
[20...1.00k]
[0.5...10.0]
[–18...+18]
[50...5.00k]
[0.5...10.0]
[–18...+18]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
[–18...+18]
[1.0 : 1...50.0 :1, Inf :1]
[–40...0]
863