014: Stereo Exciter/Enhncr; 015: Stereo Isolator - Korg Electronic Keyboard Parameter Manual

014: Stereo Exciter/Enhncr

This effect is a combination of the Exciter, which adds a
punch to the sound and the Enhancer, which adds
spread and presence.
Stereo In - Stereo Out
Left
LEQ HEQ
Exciter
EQ Trim
EQ Trim
Exciter
Right
D -mod
Pre EQ
Trim
Sets the 2-band EQ input level.
LEQ Fc
Selects the cutoff frequency (low or mid-low) of the
low-range equalizer.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Fc
Selects the cutoff frequency (high or mid-high) of the
high-range equalizer.
HEQ Gain [dB]
Sets the gain of the High EQ.
EXCITER
Emphasis Frequency
This parameter sets the frequency to be emphasized.
Higher values will emphasize lower frequencies.
Source
Selects the modulation source for the Emphasis
Frequency.

015: Stereo Isolator

This is a stereo effect that separates the input signal
into low, mid, and high-frequency bands, and controls
the volume of each band independently. For example
you can separately boost or cut the kick, snare, and hi-
hat sounds from a drum signal in realtime.
Wet / Dry
Delay
Depth
Delay
Enhancer
Wet / Dry
[0...100]
[Low, Mid-Low]
[–15.0...+15.0]
[High, Mid-High]
[–15.0...+15.0]
[0...70]
[Off...Tempo]
EQ and Filters 014: Stereo Exciter/Enhncr
Amount
Sets the amount of modulation of the frequency to be
emphasized
Blend
This parameter sets the depth (intensity) of the Exciter
effect. Positive values give a frequency pattern (to be
emphasized) different from negative values.
Source
Selects the modulation source for the Exciter intensity.
Amount
Sets the modulation amount for the Exciter intensity.
ENHANCER
L Delay Time [msec]
The L and R Delay Time parameters set the delay times
for the Enhancer's left and right channels. Specifying
slightly different delay times for the left and right
channels will add a stereo image, depth, and width to
the sound.
R Delay Time [msec]
Sets the delay time for the Enhancer's right channel.
For more information, see "L Delay Time [msec],"
above.
Depth
Sets the determines to what degree the Enhancer effect
is applied.
Source
Selects the modulation source of the Enhancer width.
Amount
Sets the modulation amount of the Enhancer width.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Stereo In - Stereo Out
Left
Low
Mid
Trim
High
Isolator
Low
Mid
Trim
High
Right
D -mod
D -mod
D -mod
[–70...+70]
[+/–100]
[Off...Tempo]
[+/–100]
[0.0...50.0]
[0.0...50.0]
[0...100]
[Off...Tempo]
[+/–100]
Wet / Dry
Wet / Dry
775