123: Limiter - Phaser - Korg Electronic Keyboard Parameter Manual

Effect Guide
Attack
Sets the attack time. p.766.
Release
Sets the release time. p.766.
Gain Adjust [dB]
Sets the limiter output gain. p.766.
CHORUS/FLANGER
Pre EQ
Trim
Sets the EQ input level.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Gain [dB]
Sets the gain of the High EQ.
LFO
Frequency [Hz]
Sets the LFO speed.
Waveform
Selects the LFO Waveform.
FLANGER
Delay Time [msec]
Sets the delay time.

123: Limiter - Phaser

This effect combines a mono limiter and a phaser. You
can change the order of the effects.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Limiter
+
Limiter
Right
Envelope - Control
Routing
[Limiter ➝ Phaser, Phaser ➝ Limiter]
Routing
Switches the order of the limiter and phaser.
LIMITER
Ratio
Sets the signal compression ratio. p.765.
Threshold [dB]
Sets the level above which the compressor is applied.
p.766.
864
[1...100]
[1...100]
[–Inf, –38...+24]
[0...100]
[–15...+15]
[–15...+15]
[0.02...20.00]
[Triangle, Sine]
[0.0...1350.0]
Routing
Phaser
Phaser
Normal
Gain Adjust
+
Output Mode
—
Wet Invert
Resonance
Phaser Wet / Dry
LFO: Tri / Sine
[1.0 : 1...50.0 :1, Inf :1]
[–40...0]
Depth
Sets the depth of LFO modulation.
Feedback
Sets the feedback amount. p.803.
Output Mode
Selects whether the chorus/flanger output is mono or
pseudo-stereo. For more information, see "Output
Mode" on page 857.
When Routing is set to Flanger→ → → → Comp, Output Mode
will automatically be set to Normal.
Wet/Dry
Sets the effect balance of the chorus/flanger. p.780,
p.804.
Source
Selects the Wet/Dry modulation source for the
chorus/flanger.
Amount
Sets the Wet/Dry modulation amount for the
chorus/flanger.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Attack
Sets the attack time. p.766.
Release
Sets the release time. p.766.
Wet / Dry
Gain Adjust [dB]
Sets the limiter output gain. p.766.
PHASER
Wet / Dry
LFO
Waveform
Selects the LFO Waveform.
Frequency [Hz]
Sets the LFO speed.
PHASER
Manual
Sets the frequency to which the effect is applied.
Depth
Sets the depth of LFO modulation.
[0...100]
[+/–100]
[Normal, Wet Invert]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
[1...100]
[1...100]
[–Inf, –38...+24]
[Triangle, Sine]
[0.02...20.00]
[0...100]
[0...100]