019: Multi Mode Filter - Korg Electronic Keyboard Parameter Manual

Effect Guide
Common 1 or 2: the steps use the frequency or tempo
sync of the selected Common LFO, so that you can
synchronize multiple LFO-based effects together.
Common LFO Phase Offset [degrees]
Sets the phase offset when Type = Common 1 or
Common 2. p.777.

019: Multi Mode Filter

This multi-mode filter includes low pass, high pass,
band pass, and band reject modes. You can modulate
the cutoff frequency and resonance from either an LFO
or dynamic modulation.
Stereo In - Stereo Out
Left
Trim
LPF
HPF
BPF
BRF
Trim
Right
LFO: Tri / Sine
MULTIMODE FILTER
Trim
Sets the input level.
Type
Selects the type of filter. For more information, see
"Filter Type" on page 61.
Cutoff Frequency
Sets the cutoff frequency (center frequency).
Source
Selects the modulation source of the cutoff.
Amount
Sets the modulation amount of the cutoff.
Depth
Sets the depth to which the LFO will modulate the
cutoff frequency.
Resonance
Sets the resonance amount.
Source
Selects the source that will modulate the amount of
resonance.
780
[+/–180]
Multimode Filter Driver
Output
Filter Type
Multimode Filter Driver
Output
LFO Phase
LFO Shape
[0...100]
[LPF, HPF, BPF, BRF]
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
[0...100]
[Off...Tempo]
OUTPUT
Wet/Dry
This sets the balance between the effect and the dry
input. From –Wet to –1:99, the effect sound's phase will
be reversed.
Source
This selects a modulation source for Wet/Dry.
Amount
This sets the modulation amount for Wet/Dry.
Amount
Sets the amount by which the resonance will be
modulated.
DRIVER
Wet / Dry
Bypass
Switches distortion on/off within the filter.
Gain
Sets the distortion amount.
Low Boost
Wet / Dry
Sets the amount of low-range boost.
Output
Sets the output level.
LFO
Waveform
Selects the LFO Waveform.
Shape
This changes the curvature of the LFO Waveform,
which emphasizes or de-emphasizes the peaks, as
shown below.
LFO Shape = 0...+100
Phase [degrees]
Sets the LFO phase difference between the left and
right. See "Phase [degrees]" on page 779.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
[–Wet, –99:1...–1:99,
Dry, 1:99...99:1, Wet]
[Off...Tempo]
[Triangle, Sine]
LFO Shape
LFO Shape = 0...—100
LFO Waveform=Sine
[–180...+180]
[0.02...20.00]
[Off...Tempo]
[+/–100]
[+/–100]
[Check-box]
[0...100]
[0...100]
[0...100]
[+/–100]