Korg Electronic Keyboard Parameter Manual page 153

Automatically-set parameters and their values
Parameter
Initialize
Analog,
Input (Input Source) :
S/P DIF
Level 127
Pan L000
Input1 : Bus Select Off
Send1 000
Send2 000
Level 127
Pan R127
Input2 : Bus Select Off
Send1 000
Send2 000
Source Bus L/R
Trigger Sampling START SW
Recording
Metronome
Setup :
Off
Precount
Resample Manual
Save to RAM
Sample
L–MONO
Mode
Sample
REC Maximum –
Time: RAM
Sample
Setup : 4min
Sample
59.999se
Time: DISK
c
Recording
+0.0
Level [dB]
REC
Auto
Sample Off
+12dB On
Preference :
Bus Select
(P8 Routing) All OSCs to L/R
:
- : Not set automatically
Values enclosed in parentheses ( ) are automatically set
according to the settings you make in the dialog box.
*1: Settings for Analog, S/P DIF ("Input 1" and
"Input 2") are made automatically.
*2: The input source setting ("Input 1" and "Input
2") you specified for "Source Audio" in the dialog
box will be set automatically.
*3: If "Source Audio" is Mono-L this will be L-
Mono, if Mono-R this will be R-Mono, and if Stereo
this will be Stereo.
*4: When "Save to: RAM," and "Convert to
Program" is checked.
3.Auto
2.REC Resampl
1.
Audio e
Input through
IFX
(Source Analog,
*1 *2 *1
Audio) S/P DIF
*3
(IFX) Off
3
(IFX)* Off
– –
Manual Auto
(Save to) (Save to)
(Source
Stereo
*4
Audio)
–
– –
+0.0 –12.0
Off On
L/R (IFX)
Program: Page Menu Commands
Copy Tone Adjust
Copy Tone Adjust is available on the Control Surface
page when CONTROL ASSIGN is set to TONE
ADJUST.
This command replaces the current Tone Adjust
settings with those of any other Program, Combination
Timbre, or Song Track.
1. Select "Copy Tone Adjust" to open the dialog box.
2. Use "From" to select the copy-source mode, bank,
and number.
You can use the front-panel BANK keys to select the
desired bank.
3. In the Timbre field (if you've selected a
Combination) or Track field (if you've selected a
Song), select the Timbre or Track to copy from.
4. Select either All or Assignments Only to specify
the Tone Adjust parameters you want to copy.
All: This copies both the Tone Adjust parameter
assignments and values.
Assignments Only: This copies only the Tone
Adjust parameter assignments, without the values.
5. Press the OK button to execute the Copy Tone
Adjust command, or press the Cancel button if
you decide to cancel.
Reset Tone Adjust
Reset Tone Adjust is available on the Control Surface
page when CONTROL ASSIGN is set to TONE
ADJUST.
This command resets the Tone Adjust settings for all of
the Knobs, Switches, and Sliders to their default
values.
1. Select "Reset Tone Adjust" to open the dialog box.
2. Use the "To" field to specify how the Knob 1–8,
SW1–16, Slider 1–8, and Master Slider parameters
will be reset.
All Off: All will be reset to Off.
Default Setting: The parameters will be reset to the
default values for the applicable type of program
(HD-1, AL-1, CX-3).
Copy Tone Adjust
143