053: Stereo Envelope Phaser; 054: Bi Phaser - Korg Electronic Keyboard Parameter Manual

Amount
Sets the modulation amount for Wet/Dry.

053: Stereo Envelope Phaser

Stereo In - Stereo Out
Left
Phaser
Phaser
Right
D-mod
D -mod
Sweep Mode
EG Attack/Decay
EG
This stereo phaser uses an envelope generator for
modulation. You will obtain the same pattern of
phasing each time you play. You can also control the
Phaser directly using the modulation source.
PHASER
L Manual Bottom
Sets the lower limit of the left-channel phaser's sweep.
For more information on the Bottom and Top settings,
see the graphic under "Frequency Bottom" on
page 777.
L Manual Top
Sets the upper limit of the left-channel phaser's sweep.
R Manual Bottom
Sets the lower limit of the right-channel phaser's
sweep.
R Manual Top
Sets the upper limit of the right-channel phaser's
sweep.
CONTROL
Sweep Mode
Determines whether the phaser is controlled by the
envelope generator or by the modulation source. p.804.

054: Bi Phaser

This effect provides two independent phasers that can
be connected in series or in parallel.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Resonance
+
Dual
Mode
Serial
LFO1
Phase Lock
LFO2
Resonance
Right
Chorus, Flanger, and Phaser
[+/–100]
Wet / Dry
Resonance
High Damp
Wet / Dry
[0...100]
[0...100]
[0...100]
[0...100]
[EG, Dmod]
Wet / Dry
Output Level1
Phaser
+
Output Mode
Phaser
Output Level2
Wet / Dry
053: Stereo Envelope Phaser
Source
Selects the modulation source that triggers the EG
(when EG is selected for Sweep Mode), or modulation
source that causes the phaser to sweep (when Dmod is
selected for Sweep Mode). p.804.
EG
Attack
Sets the EG attack time. For more information Attack
and Release, see the graphic under "Attack [msec]" on
page 766.
Decay
Sets the EG decay time.
PHASER
Resonance
This controls the intensity of the phaser. For more
information, see "Resonance" on page 805.
High Damp [%]
This sets the amount of high-frequency damping in the
phaser's feedback loop. Increasing the value will cut
high-range harmonics.
OUTPUT
Wet/Dry [–Wet...–1:99, Dry, 1: 99...Wet]
Sets the balance between the "wet" processed sound
and the dry input. Negative values invert the phase of
the wet signal. This interacts with Resonance; for more
information, see "Resonance" on page 805.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
PHASER1
Manual
Sets the frequency of phaser 1.
LFO1 Depth
Sets the LFO modulation depth of phaser 1
Source
Selects a source to control LFO modulation depth of
both phasers.
[Off...Tempo]
[1...100]
[1...100]
[+/–100]
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
[0...100]
[Off...Tempo]
807