116: Comp - Od/Higain - Korg Electronic Keyboard Parameter Manual

COMPRESSOR
Pre EQ
Trim
Sets the EQ input level.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Gain [dB]
Sets the gain of the High EQ.
COMPRESSOR
Sensitivity
Sets the sensitivity. p.764.

116: Comp - OD/HiGain

This effect combines a mono compressor and an
overdrive/high-gain distortion. You can change the
order of the effects.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Routing
Compressor
+
Comp
Output Level
Right
Envelope - Control
Routing
[Comp ➝ OD/HG, OD/HG ➝ Comp]
Routing
Switches the order of the compressor and overdrive.
COMPRESSOR
Sensitivity
Sets the sensitivity. p.764.
Attack
Sets the attack level. p.764.
Output Level
Sets the compressor output level. p.764.
OD/HI-GAIN
DRIVE
Drive Mode
Switches between overdrive and high-gain distortion.
Drive
Sets the degree of distortion. See "DRIVE" on page 789.
Output Level
Sets the overdrive output level.
[0...100]
[–15...+15]
[–15...+15]
[1...100]
Wet / Dry
Overdrive / Hi-Gain
3 Band PEQ
Driver
Wet / Dry
Output Level
Mode: Overdrive / Hi-Gain
Drive
Wet / Dry
[1...100]
[1...100]
[0...100]
[Overdrive, Hi-Gain]
[1...100]
[0...50]
Mono-Mono Serial
Attack
Sets the attack level. p.764.
Output Level
Sets the compressor output level. p.4.
AMP SIM
Amplifier Type
Selects the type of guitar amplifier.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Source
Selects the modulation source for the overdrive output
level.
Amount
Sets the modulation amount of the overdrive output
level.
Wet/Dry
Sets the overdrive effect balance.
Source
Selects the Wet/Dry modulation source for the
overdrive.
Amount
Sets the Wet/Dry modulation amount for the
overdrive.
EQ
Low Fc [Hz]
Sets the center frequency for Low EQ (shelving type).
Gain [dB]
Sets the gain of the Low EQ.
Mid1 Fc [Hz]
Sets the center frequency for Mid/High EQ 1 (peaking
type).
Q
Sets the band width of Mid/High EQ 1. p.773.
Gain [dB]
Sets the gain of Mid/High EQ 1.
Mid2 Fc [Hz]
Sets the center frequency for Mid/High EQ 2 (peaking
type).
Q
Sets the band width of Mid/High EQ 2. p.773.
116: Comp - OD/HiGain
[1...100]
[0...100]
[SS, EL84, 6L6]
[Off...Tempo]
[–50...+50]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
[20...1.00k]
[–18...+18]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
859