Table of Contents
Advertisement
Program mode: HD-1
3. To execute the Reset Tone Adjust command, press
the OK button. To exit without resetting the
controls, press the Cancel button.
Copy Oscillator
Copy Oscillator is available on all of the tabs under the
Basic/Vector, OSC/Pitch, Filter, Amp/EQ, and AMS
Mix/Common Key Track pages.
This command is used to copy the settings from one
oscillator to another.
1. Select "Copy Oscillator" to open the dialog box.
2. Use the "From" field to select the oscillator that
you want to copy.
3. Use "Program" to select the bank and number of
the copy-source program. You can press a BANK
SELECT switch to select the desired bank.
Note: If you're editing an HD-1 Program, you can't
select EXi Programs, and vice-versa.
4. If you check "Tone Adjust too," the Tone Adjust
settings will temporarily be turned off, and from
the copy-source Tone Adjust settings, the
Common portion and the assignments and current
values of the corresponding OSC portion will be
copied.
If "Tone Adjust too" is unchecked, the Tone Adjust
settings will be maintained.
5. In "To," specify the copy destination oscillator.
6. To execute the Copy Oscillator command, press
the OK button. To cancel, press the Cancel button.
Swap Oscillator
Swap Oscillator is available on all of the tabs under
the Basic/Vector, OSC/Pitch, Filter, Amp/EQ, and
AMS Mix/Common Key Track pages.
This command exchanges the settings of oscillators 1
and 2.
1. Select "Swap Oscillator" to open the dialog box.
2. To execute the Swap Oscillator command, press
the OK button. To cancel, press the Cancel button.
This can be selected only if Oscillator Mode (1–1a) is
Double.
Copy Vector Envelope
Copy Vector Envelope is available on the Vector
Envelope tab of the Basic/Vector page.
This command copies vector envelope settings from
the specified program, combination/timbre, or song.
144
1. Select "Copy Vector Envelope" to open the dialog
box.
2. Use the "From" field to select the mode, bank, and
number of the desired copy-source. You can press
a BANK key to select the desired bank.
This command copies the parameters of the P1-
Vector Envelope page of the corresponding mode.
Note: In order to replicate the way in which the
relative volume of oscillators is controlled by the
vector and vector envelope of the program selected
for a combination timbre or a MIDI song track, turn
on the Enable Program Vector Volume check box in
the Vector Control Volume page. To replicate the CC
control effects, turn on the Enable Program Vector
CC check box in the Vector Control CC page.
Use this command when you want to copy the
Position or Time/Tempo of a vector envelope in
order to create an envelope that produces the same
movement.
3. Press the OK button to execute the command, or
press the Cancel button to cancel.
Copy Pad Setup
Copy Pad Setup is available on the Pads tab of the
Basic/Vector page.
This command copies the pad settings of the specified
Program, Combination, or Song.
1. Select Copy Pad Setup to open the dialog box.
2. Use the "From" field to select the mode, bank, and
number of the desired copy-source. You can also
select Banks via the front-panel BANK SELECT
buttons.
If you press the Set To Current button, the currently
selected mode, bank, number and pad (edit cell)
will automatically be assigned to the From field.
This is useful when you're trying out other pad
settings and want to temporarily copy previously-
edited pad settings to another vacant pad.
Advertisement
Table of Contents
