017: St. Vintage/Custom Wah - Korg Electronic Keyboard Parameter Manual

MIDI/Tempo Sync
MIDI/Tempo Sync
On (checked): When MIDI/Tempo Sync is On, the
LFO will synchronize to tempo as set by BPM, below.
The LFO speed will be controlled by the Base Note and
Times parameters, below. All settings for Frequency
and Frequency Source and Amount will be ignored.
Off (unchecked): When MIDI/Tempo Sync is Off, the
Frequency settings will determine the speed of the
LFO, and the BPM, Base Note, and Times settings will
have no effect.
BPM
MIDI syncs to the system tempo. 40-240 sets the tempo
manually for this individual effect.
Base Note
This sets the basic speed of the LFO, relative to the
BPM setting. The values range from a 32nd note to a
whole note, including triplets.
Times
This multiplies the length of the Base Note. For
instance, if the Base Note is set to a sixteenth note, and
Times is set to 3, the LFO will cycle over a dotted
eighth note.
LFO Type
Type [Individual, Common1, Common2]
Individual: the LFO uses the Frequency and
MIDI/Tempo Sync parameters, above.
Common 1 or 2: the LFO uses the frequency or tempo
sync of the selected Common LFO, so that you can
synchronize multiple LFO-based effects together.
For more information, see "Common FX LFOs" on
page 730.
Common LFO Phase Offset [degrees]
This specifies the phase difference relative to the
selected Common FX LFO. It applies only when Type
is set to Common 1 or Common 2.
WAH
Frequency Bottom
This sets the wah frequency when the modulation
signal (selected by Sweep Mode) is at its minimum
level.

017: St. Vintage/Custom Wah

This effect models the tonal character of a vintage wah
pedal. You can customize the tone and range settings.
[Check-box]
[MIDI, 40.00...240.00]
[ ... ]
[x1...x32]
[+/–180]
[0...100]
EQ and Filters 017: St. Vintage/Custom Wah
To reverse the sweep direction, you can set this to be
higher than the Frequency Top, below.
Frequency Frequency
Top=75
Wah
Bottom=60
Woo
Bottom=25
D -mod
Higher
Zero Max
Frequency
Frequency
Wah
Bottom=75
Top=75
Woo
Woo
Bottom=25
Envelope
Time
Frequency Top
This sets the wah frequency when the modulation
signal (selected by Sweep Mode) is at its maximum
level.
Resonance
Sets the resonance amount.
Low Pass Filter
Switches the wah low pass filter on and off.
Output Level
Sets the output level of the effect sound.
Source
Selects the modulation source that will control the
effect output level.
Amount
Sets the modulation amount of the effect output level.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Stereo In - Stereo Out
Left
Envelope Sens Sweep Mode
+
Auto
Response
D-mod
D -mod
LFO
LFO
Right
Sweep Mode=D-mod
Wah
Woo
Top=30
D -mod
Higher
Zero Max
Sweep Mode=Auto
Wah Wah
Envelope
Top=25
Woo
Envelope Time
[0...100]
[0...100]
[Check-box]
[0...100]
[Off...Tempo]
[+/–100]
Wet / Dry
Wah
Shape / Invert
Mode
Preset Setting
Custom Parameters
Wah
Wet / Dry
777