5-2: Sample Parameters - Korg Electronic Keyboard Parameter Manual

5–2: Sample Parameters
5–1a
5–2a
Here you can edit the filter cutoff, resonance, and
three-band EQ gain for each drum sample. These
settings are offsets that are applied to the settings of
the program.
5–2a: Drumsample Parameters
DS1 (High): (Drumsample 1 High)
DS1(High) On/Off
On (checked): Check this if you want to use DS1
(High). The selected drum sample will sound.
Off (unchecked): DS1 (High) will not be used. The
drum sample will not sound.
Filter Cutoff
Adjust the cutoff frequency of the filter. The cutoff
frequency for each key and drum sample is
determined by adding this value to the filter
Frequency (Program 3–1b) of the program that uses
this drum kit.
Resonance (Filter Resonance)
This adjusts the filter resonance. This offset value for
each key and drum sample is applied to the filter
"Resonance" (Program 3–1b) of the programs that use
this drum kit.
Driver Drive
This adjusts the drive level. This offset value for each
key and drum sample is applied to the driver "Drive"
(Program 4–1a) setting of the programs that use this
drum kit.
Global P5: Drum Kit
Low Boost (Driver Low Boost)
This adjusts the low boost level of the driver. This low
boost setting for each key and drum sample is applied
to the driver "Low Boost" (Program 4–1a) setting of the
programs that use this drum kit.
3 Band Parametric EQ [dB]
Low
[Off, On]
Mid
High
These parameters adjust the gain for each band of the
three-band parametric EQ. The gain settings for each
key and drum sample are applied to the "Low Gain,"
"Mid Gain," and "High Gain" (Program 4–9a) settings
[–64...+63]
of the programs that use this drum kit.
DS2(Mid Hi): (Drumsample2 Mid High)
DS3(Mid Lo): (Drumsample3 Mid Low)
DS4(Low): (Drumsample4 Low)
[–64...+63]
Here you can edit the sample parameters for the
second, third, and fourth drum samples. The
parameters are the same as for DS1, as described
above. See "DS1 (High): (Drumsample 1 High)."
[–99...+99]
▼ 5–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
5–2: Sample Parameters
5–2PMC
[–99...+99]
[–36.0...+36.0]
[–36.0...+36.0]
[–36.0...+36.0]
677