066: Stereo Frequency Shifter - Korg Electronic Keyboard Parameter Manual

066: Stereo Frequency Shifter

This is a stereo effect that shifts the frequency of the
input signal. You can use LFO modulation and delay to
produce a wide range of pitch-change effects.
Stereo In - Stereo Out
Left
Feedback
Frequency Shifter
High Damp HPF
LFO
High Damp HPF
Frequency Shifter
Feedback
Right
FREQUENCY SHIFTER
High Damp [%]
Sets the high-frequency attenuation of the delayed
sound.
HPF Fc [Hz]
Sets the cutoff frequency for the high pass filter.
Frequency Shift [Hz]
Sets the amount of frequency shift.
Source
Selects the modulation source that will control
frequency shift.
Amount
Sets the modulation amount for controlling frequency
shift.
LFO Depth [Hz]
Sets the depth by which the LFO will modulate the
frequency shift.
Source
Selects the modulation source that will control LFO
modulation of frequency shift.
Amount
Sets the amount by which the modulation source will
control LFO modulation of the frequency shift.
LFO
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
Modulation and Pitch Shift
Wet / Dry
Post-Delay
Delay
Pre-Delay
Output Select
Delay
Wet / Dry
[0...99]
[20...11.90k]
[–6.00k...+6.00k]
[Off...Tempo]
[–6.00k...+6.00k]
[–6.00k...+6.00k]
[Off...Tempo]
[–6.00k...] +6.00k
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
066: Stereo Frequency Shifter
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on
page 777.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual
LFO, or one of the Common FX LFOs. For more
information, see "LFO Type" on page 777.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets
you offset the phase from the master LFO.
DELAY
Delay Time [msec]
Sets the delay time.
Feedback
Sets the feedback amount.
Source
Selects the modulation source of feedback amount.
Amount
Sets the depth by which feedback amount will be
modulated.
Output Select
Selects whether the pre-delay or the post-delay sound
will be output.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
[Check-box]
[MIDI, 40.00...240.00]
[ ... ]
[x1...x32]
[+/–180]
[0.0...2730.0]
[+/–100]
[Off...Tempo]
[+/–100]
[pre-delay, post-delay]
819