Korg Electronic Keyboard Parameter Manual page 403

8–1b: Routing1
Timbre 01 (Timbre Number)
Bus Select (IFX/Indiv. Out Assign) Dkit
You can select this only if the Timbre's Program is a
drum program (Oscillator Mode Drums). This
parameter can also be edited from the P8– Routing 2
page.
On (checked): The Bus Select, FX Control Bus, Send1,
and Send2 settings for each key of the selected drum
kit will be used. Check this setting if you want to apply
an individual insert effect to each drum instrument, or
to send individual drum instruments to AUDIO
OUTPUT (INDIVIDUAL).
Tip: In most preloaded drumkits, the drum
instruments have the same Bus Select settings
according to their type, as follows.
Snares → IFX1
Kicks → IFX2
Toms → IFX3
Cymbals → IFX4
Percussion, etc. → IFX5
If you want to edit these routings, use the "Drum Kit
IFX Patch" page menu command.
Off (unchecked): The Bus Select, FX Control Bus, and
Send 1/2 settings will be used. All drum instruments
will be sent to the specified bus.
Combination P8: Insert Effect
[Off, On]
Bus Select (IFX/Indiv.Out Assign)
This specifies the output bus for the timbre's program
oscillator. This parameter can also be edited from the
P8– Routing 2 page.
L/R: Output to the L/R bus.
IFX1...12: Output to the IFX1–12 buses.
1...8: The timbre will be output in mono from the
corresponding AUDIO OUTPUT (INDIVIDUAL) 1, 2,
3, 4, 5, 6, 7, or 8.
1/2...7/8: The timbre will be output in stereo according
to its pan setting from the corresponding AUDIO
OUTPUT (INDIVIDUAL) pairs 1/2, 3/4, 5/6, or 7/8.
Off: The timbre will not be output from the L/R bus,
IFX1–12 buses, or Individual 1–8 buses. Choose the Off
setting if you want the program oscillator output of the
timbre to be connected in series to a master effect. Use
Send1 (to MFX1) and Send2 (to MFX2) to specify the
send levels.
Tip: You can create a wide variety of routings by using
each timbre's Bus Select and the Chain to and Chain
settings (5–5a) that follow the insert effect.
[L/R, IFX1...12, 1...8, 1/2...7/8, Off]
8–1: Routing1
393