Korg Electronic Keyboard Parameter Manual page 759

Fig. 2–1b
Fig. 2–1c
OSC1/EXi1 Send1=127 (100%) *064 (50%)=064 (50%)
OSC1/EXi1 Send2=064 (50%) *127 (100%)=064 (50%)
OSC2/EXi2 Send1=064 (50%) *064 (50%)=032 (25%)
OSC2/EXi2 Send2=127 (100%) *127 (100%)=127 (100%)
If IFX1–12 is selected for Bus Select, use the Send1 and
Send2 parameters for the post-IFX signals. If 1–8, or
1/2–7/8 is selected instead, these Send1 and 2 settings
are ignored and the Master Effect is not applied.
Send1 responds to CC#93, and Send2 responds to
CC#91. If Send1 (to MFX1) and Send2 (MFX2)" for
each timbre/track are effective, the parameter will
be controlled on the MIDI channels set for the
corresponding timbres and tracks. If the Send1 and
Master Effects (MFX1, 2)
Send2 parameters for the post-IFX1–12 signals are
effective, they can be controlled on the MIDI
channels assigned to IFX1–12.
Note: You can use the control surface to control Send1
and 2. For details, see "8–1f: OSC MFX Send" on
page 125.
An example for Combination mode is given below. In
the upper figure (Fig. 2–2a), Bus Select is set so that
Timbre 1 is routed to IFX1, Timbre 2 to IFX2, Timbre 3
to IFX3, Timbre 4 to IFX4, Timbres 5 and 6 to IFX5, and
Timbres 7 and 16 to L/R. In this case, use Send1 and
Send2 for the post-IFX1 (001:St. Dyna Compressor)
signal to set the send level of the Timbre 1 routed to the
Master Effect. (In this example they are set to 032 and
127.) In the same way, use Send1 and Send2 for the
Routing
749