Table of Contents
Advertisement
Combination mode
Off: The signal will not be sent to a REC bus. Normally
you will leave this off.
1...4: The output of the timbre will be sent to the
corresponding REC bus. The Pan setting (0–1b) of each
timbre will be ignored, and the signal will be sent in
monaural.
1/2, 3/4: The output of the timbre will be sent in stereo
to the corresponding pair of REC buses. The signal is
sent in stereo to REC buses 1/2 or 3/4 according to the
Pan setting (0–1b) of each timbre.
Timbre 02...16 (Timbre Number)
These settings specify the program oscillator output
bus, effect control bus, and REC bus used by timbres 2
through 16. These are the same as for timbre 1. See
"Timbre 01".
8–5: Insert FX
1–1a
8–5a
8–5a: IFX
Here you can choose the type of each insert effect 1
through 12, its on/off status, chaining, and adjust the
post-IFX mixer settings. For insert effects, the direct
sound (Dry) is always stereo-in and out. The
input/output configuration of the effect sound (Wet)
depends on the effect type.
For detailed explanations of the individual effects,
please see the "Effect Guide" on page 727.
The following parameters are the same as in Program
mode. For more information, please see "8–5b: IFX" on
page 127.
396
▼ 8–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Combination. For more information, see
"Write Combination" on page 405.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy Insert Effect. For more information, see
"Copy Insert Effect" on page 149.
• 3: Swap Insert Effect. For more information, see
"Swap Insert Effect" on page 150.
• 4: Drum Kit IFX Patch. For more information, see
"Drum Kit IFX Patch" on page 410.
8–5b
However, unlike in Program mode, you can use a
different MIDI channel to modulate each effect, if
desired. This includes the post-IFX Pan (CC#8), Send1,
and Send2 settings, as well as the effect's dynamic
modulation (Dmod). To set the MIDI channel, use the
Ch parameter on the IFX 1-12 page (8–7a).
IFX1
For detailed information on these parameters, see "8–
5b: IFX" on page 127.
8–5PMC
Advertisement
Table of Contents
