Table of Contents
Advertisement
Sequencer mode
▼ 1–7: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Memory Status. For more information, see
"Memory Status" on page 524.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Rename Song. For more information, see
"Rename Song" on page 524.
• 3: Delete Song. For more information, see "Delete
Song" on page 524.
• 4: Copy From Song. For more information, see
"Copy From Song" on page 524.
• 5: Load Template Song. For more information, see
"Load Template Song" on page 524.
1–8: Set Up Controllers
0–1a
1–8a
1–8b
Here you can set the Sequencer functions of the SW1
switch, SW2 switch, and the Realtime Modulation
Knob 5–8. These settings are made independently for
each song.
When you operate these switches and knobs during
recording, the MIDI messages assigned to them will be
recorded.
1–8a: Panel Switch Assign
Here you can assign the function of the SW1 and SW2
switches. For details on the functions that can be
assigned, see "SW1/2 Assignments" on page 979.
462
• 6: Save Template Song. For more information, see
"Save Template Song" on page 525.
• 7: FF/REW Speed. For more information, see
"FF/REW Speed" on page 525
• 8: Set Location (for Locate Key.) For more
information, see "Set Location (for Locate Key)" on
page 525.
• 9: GM Initialize. For more information, see "GM
Initialize" on page 526.
• 10: Copy From Combination. For more
information, see "Copy from Combination" on
page 526.
• 11: Copy From Program. For more information, see
"Copy From Program" on page 526.
• 12: Copy Vector Envelope. For more information,
see "Copy Vector Envelope" on page 144.
Since the assignable panel switch functions of the
program assigned to each track are ignored, you can
make new settings here.
SW1
Assigns a function to the SW1 switch. The on/off
status can also be saved. When you change the
assigned function, the status will be reset to off.
Mode
Specifies the on/off action that occurs when you press
the SW1 switch.
Toggle: The function will alternate between on and off
each time you press the SW1 switch.
1–8PMC
[Off, ..., After Touch Lock]
[Toggle, Momentary]
Advertisement
Table of Contents
