016: Stereo Wah/Auto Wah - Korg Electronic Keyboard Parameter Manual

Effect Guide
XOVER FILTER
Trim
Sets the input level.
Frequency Low-Mid [Hz]
Sets the frequency at which the low and mid bands are
divided.
Frequency Mid-High [Hz]
Sets the frequency at which the mid and high bands
are divided.
ISOLATOR
Low Gain [dB]
Sets the low-frequency gain.
Source
Selects the source that will modulate low-frequency
gain.
Amount
Sets the amount by which the low-frequency gain will
be modulated.

016: Stereo Wah/Auto Wah

This stereo wah effect allows you to create sounds
from vintage wah pedal simulation to auto-wah
simulation, and much broader range settings.
Stereo In - Stereo Out
Left
Envelope Sens
+
Envelope Shape
D -mod
Right
CONTROL
Sweep Mode
This parameter selects how the wah will be controlled.
Auto makes the sweeps follow the input signal's
volume envelope. Auto-wah is frequently used for
funk guitar parts and clav sounds.
Dmod lets you control the filter directly via a
modulation source, just like a wah pedal.
LFO uses an LFO to create cyclic sweeps.
Source
Selects the modulation source for the wah when
Sweep Mode is set to Dmod.
Response
Sets the response speed when Sweep Mode is set to
Auto or Dmod.
776
[0...100]
[100...500]
[2000...6000]
[–Inf, –59...+12]
[Off...Tempo]
[–72...+72]
Wah
Sweep Mode
Auto
Response
D-mod
LFO
LFO
Wah
[Auto, Dmod, LFO]
[Off...Tempo]
[0...100]
Mid Gain [dB]
Sets the mid-frequency gain.
Source
Selects the modulation source for mid-frequency gain.
Amount
Sets the amount by which the mid-frequency gain will
be modulated.
High Gain [dB]
Sets the high-frequency gain.
Source
Selects the modulation source for high-frequency gain.
Amount
Sets the amount by which the high-frequency gain will
be modulated.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Envelope Sens
This parameter sets the sensitivity of auto-wah.
Increase the value if the input signal is too low to
sweep. Reduce the value if the input signal is so high
that the filter is stopped temporarily.
Wet / Dry
Envelope Shape
This parameter determines the sweep curve for the
auto-wah.
Level
Wet / Dry
value = 0...+100
value = 0...—100
LFO
Frequency
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
[–Inf, –59...+12]
[Off...Tempo]
[–72...+72]
[–Inf, –59...+12]
[Off...Tempo]
[–72...+72]
[0...100]
[+/–100]
Envelope Shape
Envelope
Time
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]