Korg Electronic Keyboard Parameter Manual page 240

EXi: CX-3 Tonewheel Organ
Horn Mic Distance
This adjusts the distance between the Horn and its
microphones. Lower values bring the mics closer to the
speaker.
Horn Mic Spread
This adjusts the distance between the two Horn
microphones, to widen the stereo field. Higher values
increase the stereo effect.
7–2d: Rotor
The rotor carries the low frequencies of the Rotary
Speaker. Its parameters are identical to those of the
Horn, above.
Fast Speed
This specifies the speed of the Rotor when the Speed
Switch is set to Fast.
Slow Speed
This specifies the speed of the Rotor when the Speed
Switch is set to Slow.
Acceleration
This sets how long it takes the Rotor to change from
the Slow speed to the Fast speed.
Deceleration
This sets how long it takes the Rotor to change from
the Fast speed to the Slow speed.
Start Acceleration
This sets how long it takes the Rotor to come up to
speed after the Mode Switch has changed from Stop to
Rotate.
Stop Deceleration
Specifies the time it will take for the Rotor to actually
come to rest after rotation is switched off.
This sets how long it takes the Rotor to come rest after
the Mode Switch has changed from Rotate to Stop.
Mic
The Rotary Speaker model includes two pairs of stereo
mics - one pair for the Rotor, and the other for the
Rotor.
Rotor Mic Distance
This adjusts the distance between the Rotor and its
microphones. Lower values bring the mics closer to the
speaker.
Rotor Mic Spread
This adjusts the distance between the two Rotor
microphones, to widen the stereo field. Higher values
increase the stereo effect.
7–2e: Horn/Rotor
Horn/Rotor Balance
This sets the output balance between the high
frequencies of the Horn and the low frequencies of the
Rotor.
230
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[000...100]
[Rotor, 1...99, Horn]
Speaker Simulator
This enables and disables modeling of the speaker
tone. Note that if the Rotary Speaker Off Output is set
to Pre-Crossover, the speaker simulation will also be
left out of the dry signal.
Horn Stop Phase
When the Mode Switch is set to Stop, the Horn
gradually comes to rest pointing one way or another.
This allows you to control where it will stop.
Free lets it come to rest naturally, at a more or less
random spot. The other settings, –180 to +180, let you
force it to land in a specific position.
The speaker position has a dramatic effect on the tone,
so specifying a fixed position allows you to achieve
consistent timbral results.
Rotor Stop Phase
This determines where the Rotor will land when the
Mode Switch is set to Stop. For more details, see "Horn
Stop Phase," above.
▼ 7–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Program. For more information, see "Write
Program" on page 138.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
[Off, On]
[Free, -180...+180]
[Free, -180...+180]