Table of Contents
Advertisement
4–6: Amp2 Mod.
This page controls Oscillator 2's amp modulation. It is
available only when the Oscillator Mode is set to
Double; if not, the page will be grayed out.
4–7: Amp2 EG
This page controls Oscillator 2's amp EG. It is available
only when the Oscillator Mode is set to Double; if not,
the page will be grayed out.
4–9: EQ
4–9a
This three-band EQ, with sweepable mid, is shared by
both of the Program's oscillators.
In Combis and Sequences, each timbre and track has its
own individual EQ. You can import the Program's EQ
settings into Tracks and Timbres by using the Combi
and Sequence "Auto-Load Program EQ" options.
4–9a: 3 Band Parametric EQ
In addition to using the on-screen parameters, you can
also use the front-panel Control Surface to set up most
of the EQ parameters (everything except for Bypass).
To do so:
1. Press the Control Surface Timbre/Track button.
2. Set the MIXER KNOBS switch to Channel Strip.
3. Set the Trim, Low Gain, Mid Freq, Mid Gain, and
High Gain using the knobs.
Bypass
When Bypass is checked, all of the EQ will be disabled,
including the Input Trim.
Program P4: Amp/EQ
The parameters are identical to those for Oscillator 1,
as described under "4–2: Amp1 Modulation," on
page 75.
The parameters are identical to those for Oscillator 1,
as described under "4–3: Amp1 EG," on page 78.
Bypass can be convenient for comparing the results of
the EQ with the original signal.
Input Trim
This controls the volume level going into the EQ.
High settings of the Low, Mid, and High Gain controls
can cause substantial increases in the overall level. You
can compensate for this by turning down the input
trim.
Low Gain
This controls the gain of the 80Hz Low Shelf EQ, in
increments of 0.5dB.
Mid Frequency
This sets the center frequency for the Mid sweep EQ.
Mid Gain
This controls the gain of the Mid Sweep EQ, in
[On, Off]
increments of 0.5dB.
4–6: Amp2 Mod.
4–9PMC
[00...99]
[–18.0...+18.0dB]
[100Hz...10.00kHz]
[–18.0...+18.0dB]
81
Advertisement
Table of Contents
