140: Reverb - Gate - Korg Electronic Keyboard Parameter Manual

Effect Guide

140: Reverb - Gate

This effect combines a mono reverb and a gate.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
EQ Trim
+
Pre Delay
Right
Gate+Dmpr
REVERB
Pre EQ
Trim
Sets the EQ input level.
LEQ Fc
Selects the cutoff frequency (low or mid-low) of the
low-range equalizer.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Fc
Selects the cutoff frequency (high or mid-high) of the
high-range equalizer.
HEQ Gain [dB]
Sets the gain of the High EQ.
REVERB
Pre Delay [msec]
Sets the delay time of the reverb sound and gate
control signal.
High Damp [%]
Sets the damping amount in the high range.
Reverb Time [sec]
Sets the reverberation time.
Wet/Dry
Sets the reverb effect balance.
GATE
CONTROL
Envelope Select
This chooses whether the gate is triggered by the signal
level, or controlled directly by the selected Dmod
Source.
When Envelope Select is set to Input, the gate is
controlled by a blend of the dry audio input and the
reverb output, as set by the Input Reverb Mix.
876
Reverb
Reverb Gate
Reverb
LEQ HEQ
Balance
Input Reverb Mix
Input
Envelope - Control
D-mod
Envelope Select
Gate
[0...100]
[Low, Mid-Low]
[–15.0...+15.0]
[High, Mid-High]
[–15.0...+15.0]
[0...200]
[0...100]
[0.1...10.0]
[Dry, 1:99...99:1, Wet]
[Dmod, Input]
Source
Selects the modulation source that controls the gate
when Envelope Select is set to Dmod.
Wet / Dry
Input Reverb Mix
This mixes the dry input and reverb output signals, for
controlling the gate.
Normally, set Input Reverb Mix to Dry, so that the
Wet / Dry
gate is controlled only by the dry input. If you wish to
extend the gate time, increase the Input Reverb Mix
value to include some of the wet mix as well, and
adjust the Threshold.
GATE
Threshold
Sets the gate threshold level. When the signal level
exceeds the threshold, the gate opens and the reverb
sound is heard.
Note that this applies only when Envelope Select is set
to Input. When the gate is controlled via Dmod, it
opens when the Dmod value is 64 or higher, and closes
when the value is 63 or lower.
Attack
Sets the attack time. p.772.
Release
Sets the release time. p.772.
Polarity
This lets you invert the gate on/off state. p.772.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
[Off...Tempo]
[Dry, 1:99...99:1, Wet]
[0...100]
[1...100]
[1...100]
[+, –]