Exi Program P0: Play; 0-1: Main - Korg Electronic Keyboard Parameter Manual

EXi: AL-1 Analog Synthesizer

EXi Program P0: Play

0–1: Main
0–1b
This is the main page of Program mode. For a full
description of this page and all of its functions, please
see "EXi Program P0: Play" on page 155. This section
describes only the overview display, which differs for
each individual EXi.
0–1b: Overview and Page Jump
This part of the page shows an overview of the most
important settings for the Program's two EXi
instruments. The specific parameters will vary,
depending on which EXi are being used. The specific
parameters for the AL-1 are described below.
The graphics give you a quick way to check all of these
settings at a glance. They also let you jump instantly to
any of the displayed parameters. Just touch one of the
graphics, and you'll jump to the page containing its
parameters. For instance, if you touch the Filter EG
graphic, you'll go to the Filter EG page.
Tip: Pressing EXIT several times will always bring you
back to this page.
Oscillators
This shows the waveforms selected for OSC1, OSC2,
and the Sub Oscillator. It also shows the level and
balance settings for the three Oscillators, plus the Ring
Modulator and Noise Generator. Levels are shown in
red, and balance settings in green.
Press this area to jump to the OSC Basic page. For more
information, see "4–1: OSC Basic" on page 174.
172
Common Key Zone
This shows the key zones for EXi1 and EXi2, as set on
the Common section's Program Basic page, in relation
to the entire MIDI note range. The range of the 76-note
or 88-note keyboard is also shown, as appropriate.
Press this area to jump to the Program Basic page.
Pitch
This shows the Pitch EG Select and Pitch LFO Select
settings for OSC1 and OSC2.
Touch an EG icon to jump to the Pitch EG/Mod page,
or touch an LFO icon to jump to the Pitch Common
page.
Filter
Filter Routing, Type, and Frequency Graphic
This shows the filter routing, filter type(s), and a
graphic representation of the filter frequency response,
including cutoff and resonance.
Press this area to jump to the Filter Basic page.
Amp
Driver, Low Boost, Pan, Amp Level
This shows the Amp section's Driver, Low Boost, Pan,
and Amp Level values.
If the Driver section's Bypass is on, Driver and Low
Boost are not shown.
Press this area to jump to the Amp/Driver page.