Chorus, Flanger, And Phaser; 040: Stereo Chorus - Korg Electronic Keyboard Parameter Manual

Chorus, Flanger, and Phaser

040: Stereo Chorus

This effect adds thickness and warmth to the sound by
modulating the delay time of the input signal. You can
add spread to the sound by offsetting the phase of the
left and right LFOs from each other.
Stereo In - Stereo Out
Left
LEQ HEQ
EQ Trim
LEQ HEQ
EQ Trim
Right
LFO: Tri / Sine
Pre EQ
Trim
Sets the EQ input level.
LEQ Fc
Selects the cutoff frequency (low or mid-low) of the
low-range equalizer.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Fc
Selects the cutoff frequency (high or mid-high) of the
high-range equalizer.
HEQ Gain [dB]
Sets the gain of the High EQ.
LFO
Waveform
Selects the LFO Waveform.
Phase [degrees]
Sets the LFO phase difference between the left and
right. See "Phase [degrees]" on page 779.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
Wet / Dry
Chorus
Chorus
Wet / Dry
LFO Phase
[0...100]
[Low, Mid-Low]
[–15.0...+15.0]
[High, Mid-High]
[–15.0...+15.0]
[Triangle, Sine]
[–180...+180]
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
Chorus, Flanger, and Phaser
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on
page 777.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual
LFO, or one of the Common FX LFOs. For more
information, see "LFO Type" on page 777.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets
you offset the phase from the master LFO.
CHORUS
L Pre Delay [msec]
Sets the delay time for the left channel. Setting the left
and right delay times to slightly different values allows
you to control the stereo image.
R Pre Delay [msec]
Sets the delay time for the right channel.
Depth
Sets the depth of LFO modulation.
Source
Selects the modulation source for the LFO modulation
depth.
Amount
Sets the modulation amount of the LFO modulation
depth.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
040: Stereo Chorus
[Check-box]
[MIDI, 40.00...240.00]
[ ... ]
[x1...x32]
[+/–180]
[0.0...50.0]
[0.0...50.0]
[0...100]
[Off...Tempo]
[+/–100]
797