Exi Program P0: Play; 0-1: Main - Korg Electronic Keyboard Parameter Manual

EXi Program P0: Play

0–1: Main
0–1b
Excitation
Pluck
Excitation
PCM Oscilltor
Excitation
(Mixer)
This is the main page of Program mode. For a full
description of this page and all of its functions, please
see "EXi Program P0: Play" on page 155. This section
describes only the overview display, which differs for
each individual EXi.
0–1b: Overview and Page Jump
This part of the page shows an overview of the most
important settings for the Program's two EXi
instruments. The specific parameters will vary,
depending on which EXi are being used. The specific
parameters for the STR-1 are described below.
The graphics give you a quick way to check all of these
settings at a glance. They also let you jump instantly to
any of the displayed parameters. Just touch one of the
sections, and you'll jump to the page containing its
parameters. For instance, if you touch the Filter EG
graphic, you'll go to the Filter EG page.
Tip: Pressing EXIT several times will always bring you
back to this page.
Excitation
Pluck
This area shows the selected Pluck Type and Width.
Touch this area to jump to the 4–1 Pluck and Noise
page.
PCM Oscillator
This area shows the four Multisamples selected for the
PCM Oscillator. Colors are used to distinguish
between the various possibilities, as detailed below.
Key Zone
String (Main)
String (Damping / Dispersion)
• Red: ROM Multisamples
• Green: RAM Multisamples
• Grey: Off
Touch this area to jump to the 4–2 PCM Oscillator
page.
Excitation (Mixer)
This shows the excitation Level for the Pluck, and the
AMS1 Intensities for the Noise Generator and PCM
Oscillator (since these levels will often be controlled
completely via AMS).
Touch this area to jump to the 4–4 Excitation Mixer
page.
String
String Main
This shows the Excitation Position and Decay settings
for the string.
Touch this area to jump to the 4–5 String Main page.
Damping and Dispersion
This shows the Damping and Dispersion settings for
the string.
Touch this area to jump to the 4–6 Damping and
Dispersion page.
Output
Filter
This shows a graphic representation of the filter
frequency response, including cutoff and resonance.
EXi Program P0: Play 0–1: Main
237