Korg Electronic Keyboard Parameter Manual page 404

Combination mode
Example: Inserting a single IFX into multiple timbre
Example: Inserting a separate IFX into each timbre, and then inserting an IFX at the final stage
Example: Sharing a portion of a timbre's IFX chain with another timbre
Send1 (MFX1)
Send2 (MFX2)
For each timbre, these parameters set the send level to
master effects 1 and 2. These settings are valid when
Bus Select is set to L/R or Off. When IFX 1–12 are
selected, the send levels to master effects 1 and 2 are set
by the Send1 and Send2 parameters of the Insert FX
page, after the sound has passed through IFX1–12.
If Bus Select is set to 1...8 or 1/2...7/8, these settings
are ignored.
Control change CC#93 can be used to control the
Send 1 level, and CC#91 to control the Send 2, and
modify their respective settings. These messages
will be received on the MIDI channel specified for
each timbre in the P2: MIDI channel page.
The actual send levels are determined by
multiplying this value with the send level Send1
and Send2 (Program 8–1f, 8–5b) for each oscillator
of the program selected for the timbre.
Timbre 02...16 (Timbre Number)
These settings specify the program oscillator output
bus and master effect send levels for timbres 2 through
16. They are the same as for timbre 1. See "Timbre 01".
394
[000...127]
Note: You can use the control surface to control Send1
and Send2. These can also be controlled from the mixer
[000...127]
section of the front panel, or from the P0– Control
Surface page of the LCD screen. Here's the procedure
for editing these settings from the front panel.
1. Press the CONTROL ASSIGN MIXER
TIMBRE/TRACK switch to select either timbres 1–
8 or 9–16.
2. Press the MIXER KNOBS switch to select
CHANNEL STRIP.
3. Use the MIXER SELECT 1/9–8/16 switches to select
the timbre whose send levels you want to adjust.
4. Use MIX CHANNEL STRIP "FX SEND 1" (knob 7)
and "FX SEND 2" (knob 8) to control the send
levels.
If Bus Select (IFX/Indiv. Out Assign) is set to L/R
or OFF, this will control OSC1 Send1 (to MFX1)–
OSC2 Send2 (to MFX2). If Bus Select (IFX/Indiv.
Out Assign) is set to IFX1–12, this will control
Send1 and Send2 (P8– Insert FX page).
▼ 8–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Combination. For more information, see
"Write Combination" on page 405.