Table of Contents
Advertisement
Effect Guide
Amount
Sets the amount by which the phaser 1 LFO
modulation depth will be controlled.
Resonance
This controls the intensity of Phaser 1. For more
information, see "Resonance" on page 805.
PHASER2
Manual
Sets the frequency of phaser 2.
LFO2 Depth
Sets the LFO modulation depth of phaser 2.
Amount
Sets the amount by which the phaser 2 LFO
modulation depth will be controlled.
Resonance
This controls the intensity of Phaser 1. For more
information, see "Resonance" on page 805.
LFO1/2
These are the parameters for the two LFOs, which are
identical to those in the Bi Chorus effect. For more
information, see "LFO1/2" on page 801.
MODE
Routing
Selects whether the phasers are connected in parallel or
in series. If Routing is set to Serial, the Phaser 1
Output Level and Phaser 2 Output Level settings are
ignored.
Output Mode
Selects whether phaser 1 and 2 will be routed
separately to the left and right channels, or summed to
mono.
Routing: Dual
Output Mode: Mono
Output Level1/2
Routing: Serial
Phaser1 Output Level
Sets the output level for phaser 1. This applies only if
Routing is set to Dual.
808
[+/–100]
[0...100]
[0...100]
[0...100]
[+/–100]
[0...100]
[Dual, Serial]
[Mono, Stereo]
Routing / Output Mode / Output Level 1/2
Routing: Dual
Output Mode: Stereo
Output Level1/2
[0...100]
Phaser2 Output Level
Sets the output level for phaser 2. This applies only if
Routing is set to Dual.
OUTPUT
Wet/Dry
[–Wet...–1:99, Dry, 1: 99...Wet]
Sets the balance between the "wet" processed sound
and the dry input. Negative values invert the phase of
the wet signal. This interacts with Resonance; for more
information, see "Resonance" on page 805.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
[0...100]
[Off...Tempo]
[+/–100]
Advertisement
Table of Contents
