8-5: Insert Fx - Korg Electronic Keyboard Parameter Manual

8–5: Insert FX
8–5a
In this page you can select the effect types for the insert
effects, turn them on/off, and make chaining settings.
8–5a: IFX
Here you can select the type of effect for each insert
effect 1–12, turn it on/off, make chaining settings, and
make post-IFX mixer settings. For insert effects, the
direct (Dry) sound is always stereo-in/out. The
configuration of the effect sound (Wet) will depend on
the type of effect.
IFX1
IFX1
This selects the effect type for insert effect 1.
Category/IFX Select menu
When you press the popup button, the Category/IFX
Select menu will appear, letting you select effects by
category. Use the tabs to select a category, and then
select an effect within that category. Press the OK
button to execute your selection, or press the Cancel
button to cancel.
IFX1 On/Off
Switches the insert effect on/off.
If this is off, the input will simply be passed to the
output. (Turning on 000:No Effect is the same as the
Off setting.)
8–5b
The setting will alternate between on and off each time
you press this.
Separately from this setting, you can use control
change #92 to turn all insert effects off. A value of 0
turns them off, and values of 1–127 restore the
original setting. The global MIDI channel specified
by MIDI Channel is used for this message.
Chain to
You can chain up to twelve insert effects together in
series, to create more complex effects. Set up the chain
using this parameter, and then enable it using the
Chain check box, below.
Effects must be chained in ascending numeric order.
For example, IFX1 can be chained to any of IFX2
[000...185]
through IFX12, and IFX2 can be chained to IFX3
through IFX12.
You can chain two or more effects into the same down-
stream effect. For instance, both IFX1 and IFX2 can be
chained to IFX6.
Effects can also join a chain in the middle. For instance,
you can chain IFX3 to IFX4 to IFX9, and then chain
IFX2 to IFX9 as well.
The Pan (CC#8), Bus Select, REC Bus, and Send1/2
settings apply only to the last effect in the chain.
[Off, On]
However, any effect in the chain can be sent to the FX
Control buses.
Chain
This enables the chain, as set up by the Chain to
parameter, above.
Sampling P8: Insert Effect
8–5PMC
8–5: Insert FX
[IFX2...IFX12]
[Off, On]
605