047: Polysix Ensemble; 048: Stereo Flanger - Korg Electronic Keyboard Parameter Manual

047: Polysix Ensemble

This models the ensemble effect built into the classic
Korg PolySix programmable polyphonic synthesizer.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Polysix
+
Ensemble
Right
POLYSIX ENSEMBLE
Depth
Sets the depth of the effect.

048: Stereo Flanger

This effect gives a significant swell and movement of
pitch to the sound. It is more effective when applied to
a sound with a lot of harmonics. This is a stereo
flanger. You can add spread to the sound by offsetting
the phase of the left and right LFOs from each other.
Stereo In - Stereo Out
Left
Flanger
Flanger
Right
LFO Shape
LFO: Tri / Sine
FLANGER
Delay Time [msec]
Sets the delay time from the original sound.
Depth
Sets the depth of LFO modulation.
Feedback
This controls the intensity of the flanger effect. Positive
and negative values create different timbres.
Mixing the processed and dry signals via Wet/Dry will
enhance the effect. For maximum intensity, set
Feedback and Wet/Dry so that they are either both
positive or both negative; this emphasizes the flanger's
harmonic peaks.
High Damp [%]
This parameter sets the amount of damping of the
feedback in the high range. Increasing the value will
cut high-range harmonics.
Wet / Dry
Wet / Dry
[0...100]
Wet / Dry
Feedback
High Damp
Wet / Dry
LFO Phase
[0.0...50.0]
[0...100]
[+/–100]
[0...100]
Chorus, Flanger, and Phaser
Source
Selects the modulation source that will control the
effect depth.
Amount
Sets the amount by which the effect depth will be
modulated.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
LFO
Waveform
Selects the LFO Waveform.
Shape
Changes the curvature of the LFO Waveform. p.780.
Phase [degrees]
Sets the LFO phase difference between the left and
right. See "Phase [degrees]" on page 779.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source
This selects a modulation source for the Frequency.
Amount
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on
page 777.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual
LFO, or one of the Common FX LFOs. For more
information, see "LFO Type" on page 777.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets
you offset the phase from the master LFO.
047: Polysix Ensemble
[Off...Tempo]
[+/–100]
[Triangle, Sine]
[+/–100]
[–180...+180]
[0.02...20.00]
[Off...Tempo]
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...240.00]
[ ... ]
[x1...x32]
[+/–180]
803