Table of Contents
Advertisement
Category/MFX Select menu
MFX2
MFX2
MFX2 On/Off
Return 2
These parameters specify the effect type for master
effect 2, its on/off status, and the return level from
master effect 2 to the L/R bus. See "MFX1" on
page 134.
Chain:
Chain On/Off
On (checked): Chain (series connection) will be
turned on for MFX1 and MFX2.
Chain Direction
[MFX1→MFX2, MFX2→MFX1]
Specifies the direction of the connection when MFX1
and MFX2 are chained.
MFX1→MFX2: Connect from MFX1 to MFX2.
MFX2→MFX1: Connect from MFX2 to MFX1.
Chain Level
When chain is On, this sets the level at which the
sound is sent from the first master effect to the next
master effect.
9–1b: TFX1, 2
These are the parameters for total effect 1 and 2, which
are placed at the final stage of the L/R bus. After
passing through the total effects, the sound is output to
AUDIO OUTPUT (MAIN OUT) L/MONO and R.
For the total effects, the direct sound (Dry) is always
stereo-in/out. The input/output configuration of the
effect sound (Wet) will depend on the selected effect
type.
Program P9: Master/Total Effect
The total effects are stereo-in and stereo-out, but the
output may be monaural depending on the type of
[000...185]
effect you select. (See "In/Out" on page 734.)
[Off, On]
TFX1
[000...127]
TFX1
This selects the effect type for total effect 1. You can use
any of the available effects, without limitation.
Category/TFX Select menu
When you press the popup button, the Category/TFX
Select menu will appear, letting you choose effect types
by category. Use the tabs to select an effect category,
[Off, On]
and then choose an effect within that category. Press
the OK button to execute your choice, or press the
Cancel button to cancel.
TFX1 On/Off
This turns total effect 1 on/off. If this is off, the input
will be passed directly through. The setting will
[000...127]
alternate between on/off each time you press this.
Separately from this setting, you can use control
change #95 to turn both total effects off. A value of 0
turns them off, and values of 1–127 restore the
original setting. The global MIDI channel specified
by MIDI Channel (Global 1–1a) is used for this
message.
TFX2
TFX2
TFX2 On/Off
These parameters specify the effect type and on/off
status for total effect 2. See "TFX1" on page 135.
9–1: Routing
[000...185]
[Off, On]
[000...185]
[Off, On]
135
Advertisement
Table of Contents
